Trouble shooting, 1080 hd-sdi camera – Marshall Electronics CV342-CSB / CS User Manual
Page 27

27
1080 HD-SDI Camera
TROUBLE SHOOTING
PROBLEM
SOUTION
Nothing appears on the screen.
Check that the power cord and line connection between the camera and
monitor are properly connected.
Check that video cable is connected with the Analog BNC (Yellow).
When the camera’s HD-SDI BNC output is directly connected to the
monitor’s BNC terminal: Make sure the monitor supports HD-SDI signal input.
When the camera’s HD-SDI BNC output is connected to the DVR: Make
sure the DVR supports HD-SDI signal input.
HD-SDI output is converted into other format such as DVI and VGA by
using video converter: Make sure the converter’s HD-SDI input format
The image on the screen is dim.
Is lens stained with dirt? Clean your lens with soft, clean cloth.
Set the monitor to the proper condition.
If the camera is exposed to very strong light, change the camera position.
Re-adjust the back-
Theimage on the screen is dim, when
the LED is on.
Check if the LEDs are shaded and reflected by the camera ring, camera base, or other
objects near the camera.
TheLEDs are reflected over the
dome or cover.
Check if the LEDs are shaded and reflected by the camera ring, camera base, or other obje
cts near the camera.
The image on the screen is dark.
Adjust the contrast feature of the monitor.
If there is an intermediate device, set 75Ω properly; Check the termination.
The camera is not working
properly, and the surface of the
camera is hot.
Check that you have properly connected the camera to an appropriate
power source.
The SENS-UP function does not
work.
Check that AGC of EXPOSURE SETUP menu is ‘OFF’.
The Motion Detection function
does not work.
Check that MOTION DET of SPECIAL SETUP menu is ‘OFF’.
Color is not correct.
Check the setting of WHITE BAL SETUP menu .
The screen flickers continually.
Ensure the camera is not pointing towards the sun.
Is the camera framing the sun or other bright light source?
If there is an intermediate device, set 75OΩ properly; Check the termination.
HD-SDI video may not appear to be normal if distance exceeds the
maximum transferrable distance.
When a BNC cable adaptor is used to combine two or more BNC cables
for distributed HD-SDI video transfer, make sure the impedance of the
adaptor is 75Ω. Otherwise, it may cause shorter transfer distance or
broken video transfer.