Logosol M8 - Manual (Page 5)

PH260 or DH410 with moulding knives for bottom, sides and joists.
Jigsaw
Electric slide compound saw with a linear length of stroke of at least
100 mm and adjustable cutting depth (Art. No. 95-210)
Handheld belt sander
Sandpaper on a block
Rubber mallet or plastic hammer
Carpenter’s hammer
Electric screwdriver with screw bit
Spanners: two 18 mm, one 13 mm
Polygrip pliers
Angular grinder with abrasive cut-off wheel
Strong electric drill
8 mm metal drill bit
8 mm wood drill bit
65 mm hole saw (check the diameter of the outlet)
Two C-clamps
Pencil, tape measure, folding rule, set square
Four 100 mm nails
Transparent silicone
Approx. 120 screws, 35 mm (The screws should be of good quality,
preferably Torx.)
Approx. 50 screws, 25 mm (The screws should be of good quality,
preferably Torx.)
Eight stainless carriage bolts M8x60 and nuts
Tools needed