MCZ Guttuso - Manual (Page 13)

INSTALLATION AND USE MANUAL Chapter 3
GUTTUSO page 13
Chapter 3 Technical service – all rights reserved by mcz spa
Reproduction prohibited
3.7. PHASE 6 - ASSEMBLY OF HOOD SUPPORT (element 4)
Set the hood support (element 3) on the sides (element 2), ensuring that it is aligned with the cladding. Push
the hood support towards the fireplace stove until the inner surface of the visible bend is flush with the counter-
wall (see drawing). Fasten the hood support with the 4 screws for plasterboard 3.9x35 provided. The outermost
screw corresponds to the metal profile that protects the corner of the counter-wall. The innermost screw is at the
steel upright. If necessary, you can make a third hole for installation of the hood support (see drawing).
FORO DA
REALIZZARE
IN OPERA
MURO PERIMETRALE
MUR
O
PERIM
ETRAL
E
SUPERFICIE INTERNA
SUPPORTO CAPPA
A FILO CON
CONTROPARETE
98
N.B. The hood support is deep enough to house both the hood and the a panel of insulating
material. The total space available is 98 mm.