MCZ Kasai - Manual (Page 18)

Chapter 4
USE AND MAINTENANCE MANUAL
page
18
Installation and assembly Technical dept. - All rights reserved by MCZ GROUP S.p.A. - Reproduction
prohibited
The stove must always be handled very carefully in vertical position and
only with trolleys. Pay special attention to the door and its glazing, to
protect them from mechanical knocks which would compromise their
good working order.
If possible, unwrap the stove near the chosen place of installation.
The materials making up the packaging are neither toxic nor harmful,
and so require no particular disposal measures.
Storage, disposal or any recycling is under the responsibility of the end
user in compliance with the applicable laws in force.
4.2. FOOT ASSEMBLY AND ADJUSTMENT
Some models envisage the assembly of support feet, designed to level
the stove so that it is aligned and stable on the floor. The feet are
screwed into the base of the structure, and they can be installed as
illustrated in the figure and adjusted with a screwdriver, inserting it into
the tip of the feet.
4.3. SIDE CLADDING ASSEMBLY
The installation of the metal sides does not present any particular
difficulties.
1. Take the central piece “3” and a side piece (“4” or “5”) out of
the packaging and, using the two trilobe screws “c”, screw it
onto piece “3” to achieve the piece as shown in figure 5.
Repeat the operation on the other side part.
3
4
5
3
4
5
c
To facilitate threading, it is advisable to carry out the
threading first without metal sheet to avoid any
impediments.
Figure 5 - Kasai stove base