System settings, Restoring the factory settings (factory reset) – Edirol UA-1000 User Manual
Page 44
44
System settings
Restoring the factory settings (Factory Reset)
fig.system
1.
While simultaneously holding down the
output volume select
switch
and the
STEREO/MONO select switch
, turn on the
power.
The
output volume select switch
and the
STEREO/MONO select
switch
will blink.
2.
Press the
STEREO/MONO select switch
once again.
The output volume select switch and the
STEREO/MONO select switch
will blink faster, and then the
direct
monitor soft control switch (SOFT CTRL)
will light.
(The operation will be cancelled if you press any LED switch other than the
STEREO/MONO select switch
.)
Once the
direct monitor soft control switch (SOFT CTRL)
has lighted, the output volume select switch and
the
STEREO/MONO select switch
will go out.
The factory settings have now been restored.
Factory settings
* For details of the UA-1000's internal block structure when it is shipped from the factory, refer to
Function
State
STEREO/MONO select switch
STEREO
Direct monitor soft control switch
On
ADAT
Off
EXT CLOCK
Off
Output volume mode
MAIN
Hold down simultaneously
and turn on the power
UA-1000_e.book 44 ページ ２００３年８月６日 水曜日 午前１１時５２分