Edimax Technology EW-7205AP - Manual (Page 28)

Wireless LAN Access Point Configuration
26
Authorization Table Enable
If checked, only devices with MAC Addresses in the Authorization Table can
connect to the Access Point.
Enable SNMP Traps
Pull down the Setup menu and select the Enable SNMP Traps submenu to
enable or disable SNMP traps. SNMP Traps are messages indicating the action of
the Access Point displayed in the right bottom corner of the main window.
Trap Reassociation
This trap message is sent when a station’s reassociation request is received
from the Access Point-Bridge.
Trap Association
Indicates the reception of an association request packet and the sender
station's successful association with the Wireless Bridge.
Trap Disassociation
This trap message is sent when a disassociation notification packet is received
from a station.
Trap Reset
This trap message is sent when the Access Point-Bridge resets.