Edimax Technology EW-7205AP - Manual (Page 25)

Wireless LAN Access Point Configuration
23
Access Point Name
Fill in a user-friendly name for the Access Point.
ESSID
This is an up to 32 characters ASCII string used to identify a WLAN that
prevents the unintentional merging of two co-located WLANs. The ESSID
value must be the same in all stations and Access points in the extended
WLAN.
Channel
There are 14 channels available. The channels differ from country to country.
Regulatory Domain
This parameter is used to designate the Access Point’s regulatory domain.
There are seven domains you can set including FCC, DOC, ETSI, SPAIN,
FRANCE, MKK and MKK1. Note that the Regulatory Domain and the
Wireless Channel parameter have the specific corresponding relation listed as
below.
FCC (USA): 1-11
DOC (Canada): 1-11
ETSI (Europe): 1-13
SPAIN: 10-11
FRANCE: 10-13
MKK: 14
MKK1: 1-14
Fragmentation Threshold
The size of the packets will be fragmented. Select a setting within a range of
256 to 2346 bytes.
RTS Threshold
Minimum packet size required for an RTS (Request To Send). For packets
smaller than this threshold, an RTS is not sent and the packet is transmitted
directly to the WLAN.
Rate
The basic transfer rates should be set depending on the speed of your wireless
networks. Select the basic rates to be used among the following options 1-
2Mbps, 1-2-5.5-11Mbps.