Silvercrest SKRI 2000 A1 - Manual (Page 133)

130
Handling and operation
SKRI 2000 A1
GB
Interrupting the kitchen timer.
When the kitchen timer is running, press the button Timer ♦ 8 , or the button
Timer 37 on the remote control. The kitchen timer is interrupted. The indicated
remaining time begins to blink.
NOTICE
After approx. 15 seconds the appliance reverts back to the previous opera- ►
tional mode. Press the button Timer 8 , or the button Timer 37 on the remote
control, once again to display the remaining time to elapse on the kitchen timer.
To restart the kitchen timer, press the button Timer ♦ 8 , or the button Timer 37
on the remote control, once again. The kitchen timer restarts.
To switch the kitchen timer off before the expiry of the set period, press and ♦
hold the the button Timer 8 , or the button Timer 37 on the remote control,
until in the display the cooking pot symbol and the backwards running
clock are no longer indicated.
NOTICE
The kitchen timer is switched off immediately in the event of an alarm ►
becoming active.
Programming the kitchen timer
So that it is no longer necessary to continually re-enter them, you can prepro-
gramme the kitchen timer with the most frequently used time periods. Up to
6 time periods can be preprogrammed. By default, the six memory slots are
preprogrammed with 5/10/15/20/25/30 minutes.
For the programming of the kitchen timer proceed as follows:
Press the button Timer ♦ 8 , or the button Timer 37 on the remote control, to
activate the kitchen timer.
Using the buttons ♦ / Up
17
and i i / Down
19
, or the / Up- button
42 and the / Down-button 32 on the remote control , set the desired run-
ning time for the kitchen timer. With each press on the button the start time
changes by one minute. Holding the button down for more than 2 seconds
starts the speed setting.
Press the button Function / ST ♦ 7 , or the button Function / ST 38 on the
remote control, to activate the kitchen timer. Next to the time display a blink-
ing is indicated, next to it appears a number for the fi rst timer.
Using the buttons ♦ i i / Pr+ / AL1 18 and i i / Pr– / AL2 16 , resp. the Pr+
button 40 or the Pr– button 44 on the remote control, select the memory
slot for the interval to be saved, between and .
IB_63920_SKRI2000A1_LB2.indb Abs3:130 17.01.2012 12:06:52 Uhr