Silvercrest SKRI 2000 A1 - Manual (Page 123)

120
Setting up and connecting
SKRI 2000 A1
GB
Place the appliance aslant, with the front recesses in the top face of the ♦
appliance, in the mounting plate 20 . Press the rear part of the appliance
upwards against the mounting plate 20 until the appliance audibly locks
into place.
Check to ensure that the appliance is securely seated. ♦
Disinstallation
Pull the appliance forwards and remove the appliance downwards. ♦
Unscrew the screws on the mounting plate ♦ 20 and remove the mounting
plate 20 .
Setting the appliance up
As an alternative you can stand the appliance on a level surface. In order to
avoid the ventilation slots and speaker
23 on the bottom of the appliance being
covered, the two foot-pads 21 on the appliance must be hinged outwards:
Reach into the recess on the side of the respective foot-pad and pull the ♦
hinged foot out as far as it will go.
Select a suitable installation location for the appliance (see also the section ♦
Set-up location requirements p. 117).
Preparing the station for iPod/iPhone
You can connect your iPod/iPhone to the appliance. For this you must fold the
station
29 down and install the locking clip 22 :
Fold the station ♦ 29 all the way down.
Remove the locking clip ♦ 22 from the side of the appliance.
On each side of the station ♦ 29 there is a recess. Slide the locking clip 22
from the front onto the station 29 so that the retaining lugs engage in the
recesses.
Providing mains power
Connect the connector plug of the power adapter ♦ 15 into the DC socket 25
on the rear panel of the appliance.
Insert the power adapter ♦ 15 into a mains power socket.
VHF wire antenna
Unwind the wire antenna ♦ 27 completely for VHF reception.
IB_63920_SKRI2000A1_LB2.indb Abs3:120 17.01.2012 12:06:32 Uhr