Silvercrest Z31279 - Manual (Page 26)

26 GB/MT
Adjusting the time
On inserting a battery, you immediately enter
the time adjustment mode (see Fig. G). Alterna-
tively, press the kg / lb / st button
7 for 3 secs
while in the time mode to enter the time adjust-
ment mode. The hour indicator flashes in the
display.
Press the temperature button 4 , to set the
hours in the 24-hour format.
Confirm your entry by pressing the kg / lb / st
button
7 . The minute indicator flashes in the
display.
Press the temperature button to set the minutes.
Confirm your entry by pressing the kg / lb / st
button
7 .
Room temperature /
time display
Press the temperature button 4 twice to switch
to temperature mode.
In the temperature mode (see Fig. H) press the
kg / lb / st button 7 to cycle between °C and °F.
After 17 seconds or pressing the temperature button
4 , the scales return automatically to the time mode
(see Fig. G).
Setting the units of weight
Note: The standard unit of weight is kilogram (kg).
The factory default setting for the scales as supplied
is “kg”.
In the weighing mode press the kg / lb / st but-
ton
7 to select the unit of weight. The units
will be displayed in the LC display as follows:
Kilogram (kg): see Figure A
Pound (lb): see Figure B
Stone (st:lb): see Figure F
Switching on your scales /
measuring your weight
Tip: Weigh yourself at the same time of day
(preferably in the morning) after visiting the toilet,
with an empty stomach and without clothing to
ensure that your results are compatible.
Place the scales down on a solid, flat horizontal
surface.
Do not place the scales on a carpet, otherwise
this may influence the results. If necessary you
can place a board on the carpet and place the
scales upon this. A solid floor covering is re-
quired in order to achieve correct weight meas-
urements.
Switch on the scales by stepping onto it.
Note: First four eights appear briefly, as
shown in Fig. I This activates the vibration sen-
sor in the scales. The scales are ready to meas-
ure your weight.
Place even weight on each leg.
If at all possible stand on the same areas of the
platform
3 each time and do not move.
Moving during the weighing process can lead
to discrepancies in the results.
The scales will start to measure immediately.
After blinking three times, the weight display
will display the result.
Note: If the scales show “ERR” (see Fig. D),
it signals that the scales are overloaded.
Observe the maximum capacity of
150 kg / 330 lb / 23 st.
Note: If the scales show „C“ (see Fig. E) when
you step off the scales, it signals that this weight
reading with an error, please measure again.
Step off the platform. The scales switch to time
mode automatically after about 20 seconds. Un-
til then the weight measurement remains visible.
Note: After a change of location and follow-
ing every battery change, the scales must be
re-calibrated. To do this, proceed as follows:
Step onto the scales. The scales will show you
an incorrect measuring result. Step off the plat-
form. The scales will calibrate automatically.
Wait until the scales switch to time mode auto-
matically.