Assembly – Silvercrest SEKU 2000 A1 User Manual
Page 74
73
Assembly
SEKU 2000 A1
GB
MT
Step 7
Screw the 6 single locking pins
♦
D
with a screwdriver into the holes provided on the front and rear
support frame plates.
Place the 6 adapter sleeves
♦
E
in the large pre-drilled holes in the three middle support frame plates.
Thereby, line up the adaptor sleeves
E
with the screwdriver so that the arrow on the adaptor sleeves
points to the outer edge.
Then, bring all of the plates together so that the single locking pins
♦
D
engage the holes in the middle
support frame plates.
When done, screw all adapter sleeves
♦
E
to the right with the screwdriver until the single locking pins
D
are clamped into the adapter sleeves
E
and the panels are seated fi rmly together and at right angles.
Step 8
Take the support frame
♦
6
and insert 3 wood plugs
B
into the holes of the front plate underside.
Then place the support frame
♦
6
on the fl oor plate
7
so that the 3 wood plugs fi t into the 3 holes in the
fl oor plate.
Rear view
Front View
D
D
E
E
6
7
B
B
Buch_66252_LB5.indb Abs3:73
08.06.2011 14:59:16 Uhr