Silvercrest SMZS 1600 A1 - Manual (Page 65)

65
4 Maintenance
GB
CY
IE
4 Maintenance 4.1 Emptying the dust con-
tainer „ Empty the dust container when the red warning light
goes on (Fig. 19) or when the MAX mark has been reached
(Fig. 20/2).
1. Unlatch the hose by the release catch (Fig. 20/1) and
detach the hose.
2. Remove the dust container by unlocking it (Fig. 21/1.)
and then folding it down (Fig. 21/2.).
3. Empty the dust container either
„ by opening the bottom plates (Fig. 22):
- Hold the container low over a dustbin before doing
this.
- Unlock the outer bottom plate (Fig. 22/1.).
- Then unlock the inner bottom plate (Fig. 22/2.).
or
„ by removing the cyclone unit (Fig. 23):
- Unlock the cyclone unit as shown (Fig. 23/1.).
- Detach the container from the cyclone unit (Fig. 23/
2.).
- Empty the container into a dustbin.
ATTENTION:
Before emptying the dust container switch off the appli-
ance and observe the notices under
ZChapter 3.2,
"Switching off and retracting power cord". In this way you
avoid dust destroying the appliance.
NOTE:
Be careful when removing the dust container so that no
dust escapes.
NOTE:
You can dispose of the contents of the dust container
with your regular domestic trash if it contains no waste
materials prohibited in domestic trash.
19
20
21
22
23