Silvercrest SMZS 1600 A1 - Manual (Page 64)

64
3 Operation
3.2 Switching off and
retracting power cord 1. Switch off the cylinder vacuum cleaner with the on/off
switch (Fig. 17/1) and pull the plug from the mains sock-
et.
2. Keep the plug in your hand.
3. Push the cord retracting button (Fig. 17/2) to retract the
power cord.
3.3 Transport and storage „ To transport the cylinder vacuum cleaner you can car-
ry it by the handle (Fig. 1/9).
„ To park the appliance or during work breaks, you can
hang the parking hook into the parking hook holder
(Fig. 18).
It is recommended to first retract the telescopic tube.
„ Before storing the appliance for a prolonged period,
empty the dust container ZChapter 4.1, "Emptying the dust
container" and dispose of its contents properly.
„ Always store the appliance in a cool, dry place and out
of reach of children.
NOTE:
Your vacuum cleaner is equipped with a safety switch to
prevent overheating. It automatically cuts off the power
supply if the motor is overheated. In this case switch off
the vacuum cleaner with the on/off switch and pull the
plug from the mains socket. Eliminate the cause of over-
heating (e.g. clogged suction paths). Wait for about
45 minutes. After the appliance has cooled off, you may
switch it on again.
WARNING:
Danger of injury! During uncontrolled retraction the
power cord can whip around, become a tripping hazard
or knock over objects. Therefore, keep the plug in your
hand and guide it when retracting the power cord.
17
WARNING:
Danger of injury! Switch off the appliance when not work-
ing with it and observe the notices under
ZChapter 3.2,
"Switching off and retracting power cord".
ATTENTION:
Never store the appliance next to heat sources
(e.g. stoves or radiators). Avoid exposing it to direct sun-
light. Heat can damage the appliance.
18