Electrolux EMS17206 - Manual (Page 35)

electrolux installation 35
Installation
Installing the appliance
1. Remove all packaging and check
carefully for any signs of damage.
2. This oven is designed to fit into a
360 mm high cupboard as
standard. When fitting into a
350 mm high cupboard:- Unscrew
and remove the 4 feet from the
bottom of the oven. There are 3 tall
feet and 1 short foot. Replace the
3 tall feet with those provided in
the accessory pack. Do not
replace the short foot.
3. If fitting the microwave oven above
a conventional oven (position A on
page 37) then use the mylar sheet
provided.
a. Cut the Mylar sheet to fit the
internal width of the unit.
b. Peel back the protective cover
on the tape and fix to the rear of
the shelf so that it covers the
service gap. (See diagram
below).
Mylar sheet
Conve
ntional
oven
Serv
ice g
ap
Interna
l width
4. Fit the appliance into the kitchen
cupboard slowly, and without
force, until the front frame of the
oven seals against the front
opening of the cupboard.
5. Ensure the appliance is stable and
not leaning. Ensure that a 5 mm
gap is kept between the cupboard
door above and the top of the
frame (see diagram).
6. Fix the oven in position with the
screws provided.
The fixing points are located on the
top and bottom corners of the oven
(see diagram, item 9, on page 9).
7. It is important to ensure that the
installation of this product
conforms to the instructions in this
operation manual and the hob or
conventional oven manufacturer’s
installation instructions.
5 mm
EX-22F-UK English:NEW Electrolux_CS BASE_English 24/4/07 11:02 Page 35