Eclipse - Fujitsu Ten CD1200 - Manual (Page 33)

How to operate the tuner
33
VI
Changing the reception
sensitivity
The main unit lets you select the reception
sensitivity. The two sensitivity modes available
for this main unit are LOCAL mode and DX
mode.
The Menu Selection mode is activated.
The mode will switch between
LOCAL mode and DX mode each
time the button is turned.
The selected settings will take effect.
Changing the radio band location
The location for the radio bands used between
the North American region and the Asia/
Australia/South American (Latin) region can be
switched. The default setting is USA (North
America).
The radio band switches in the order
shown below each time the buttons
are pressed.
USA
→ LATIN → ASIA → AUS →
USA www
When the power is turned on, the
broadcast stations will be searched for
automatically and stored in buttons [1]
to [6].
LOCAL
Mode
The reception sensitivity is set to the
low level so that stations with strong
signals are received.
DX Mode
Because the reception sensitivity for
automatic scanning is set to the high
level from the start, even stations
with weaker signals can be received.
(Signal crossover may result in
some stations being hard to hear.)
1 1 Press the [FUNCTION] button.
2 2
Press the [SELECT] button
repeatedly, until DX/LOCAL mode
is selected.
3 Turn the [VOL] button.
1 1
Check that the main unit is in
standby mode.
2 2
Press and hold button [6], then the
[BAND/ASM] button, and hold both
for more than two seconds.