Eclipse - Fujitsu Ten CD1200 - Manual (Page 29)

How to operate the USB music file player
29
V
Listening to music files in USB
memory
For details, refer to "Switching Audio
Modes" on page 14.
The procedure for playing music is the
same as that are used to play CDs.
Refer to “How to operate the CD/MP3/
WMA/AAC player” (page 22 - 25).
ATTENTION
If the USB mode is changed to another mode
and then returned to the USB mode, the player
will return to the previous file played.
Searching for a music file
You can retrieve your desired track in Search
mode.
:
The search mode is activated.
:
Search mode items are selected in
the following order.
Track search
→ File search →
Character search
For Track or File Search
Playback of the selected music file will
begin.
For Character Search
The selected character will be
confirmed.
Playback of the selected music file will
begin.
1 1
Connect a USB memory using the
USB connector.
2 2 Switch to the USB mode.
3 3 Operate the USB music file player.
CAUTION
1 2
• Do not disconnect the USB memory or turn
the ignition key to ACC OFF position while
accessing the USB memory. Doing so may
corrupt the data.
• Depending on the type connected, the USB
memory may not work in some cases.
• The USB memory does not support multi-
partition. Also, it does not support USB hub.
• It is highly recommended to back up your
data in case of accidental deletion.
• Install and use the USB device in a place
that provides safe operation of the vehicle.
• The music files under the copyright
protection cannot be played.
• When connecting a digital audio player to
the USB connector, additional USB
adaptors may be required.
1 1 Press the [BAND/ASM] button.
2
Press the [BAND/ASM] button to
select the search mode item.
3
Turn the [VOL] button to select the
track number and file number.
4
Press and hold the [SELECT]
button.
3
Turn the [VOL] button to select the
character.
4 Press the [SELECT] button briefly.
5
Repeat steps (3) and (4) to enter all
of the characters.
6
Press and hold the [SELECT]
button.