Eclipse - Fujitsu Ten CD1200 - Manual (Page 32)

32
Operation
Automatically storing stations
into memory (The automatic
preset mode: ASM)
The automatic preset mode starts.
[ASM] will appear on the display, and
stations are automatically entered in
memory under buttons [1] to [6].
These buttons are called preset
buttons.
ATTENTION
• Pressing the preset buttons ([1] to [6])
allows you to make one-touch station
selections. The frequency of the selected
station is indicated on.
• When a new station is set in memory, the
station previously set in memory will be
deleted.
• If there are fewer than six receivable
stations, the stations set in the remaining
buttons will be retained.
Manually storing stations into
memory
Store a station to a preset button.
The selected stations is now stored
in a preset button.
Repeat the above procedure to store
additional stations one at a time in
buttons [1] to [6], and store them in
memory.
1 1
Press the [BAND/ASM] button for
more than two seconds until a
beep is heard.
CAUTION
1 2
If the vehicle's battery is disconnected (for
repairs to the vehicle or for removing the
main unit), all stations in memory will be
lost. In such a case, store stations in the
memory again.
1 1
Press the [TRACK/SEEK] button to
tune to the station to be entered in
memory.
2 2
Select any button, from [1] to [6],
and press it for more than two
seconds.
CAUTION 1 2
If the vehicle's battery is disconnected (for
repairs to the vehicle or for removing the
main unit), all stations in memory will be
lost. In such a case, store stations in
memory again.