Sealey AP7150C - Manual (Page 2)

4.1. Assemble the racking unit following the sequence below, referencing the parts list overleaf. no tools are required
although a mallet is useful for tapping the brackets together.
4. aSSeMbly
Original Language Version
AP7150c Issue: 1 - 22/08/12
© Jack sealey Limited
fig.1
fig.2
fig.3 fig.4
4.2. Place foot caps onto the bottom of legs H and I. Place
rear shelving brackets A onto the legs. A rubber mallet
can be used to lightly tap the brackets into place in the
keyholes in the legs (note the upright position of the
keyhole).
4.3. fit shelf bracket B for the side brackets at the same
height as shelf bracket A, then fit shelf bracket E. Fit
brace G as shown above.
4.4. Join the lower and upper legs with the connector pins
as shown in fig.3 (note the upright position of the
keyhole).
4.5. fix shelf brackets A so that the top rivet sits in the
upper legs and the lower rivet sits in the lower legs.
repeat with shelf brackets B and E, followed by brace
G, at the same level.