Sealey CST988 - Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
3. FEATURES
2. SPECIFICATION
3.1 CST988.V3 is a case carrying model with a high back and flat loading capabilities.

Always load evenly with the centre of gravity of the load as near the centre and rear of the plate as possible.
 Obtain additional support for large or wide loads to prevent tipping.
 DO NOT overload the truck - see Specification.
 DO NOT leave unattended, especially when loaded, unless the wheels are chocked or the truck is otherwise secured.
 DO NOT use truck on uneven ground and DO NOT run over curbs or steps - use a ramp.
 DO NOT allow others to ride on the truck.
 DO NOT use the truck if any part is damaged, paying particular attention to the wheels.
4.1 Wheels Ensure axle is clean from dust and dirt to allow free movement of the wheel.
4.2 The axle (1.1) needs to be put through the frame before the wheels can be attached.
4.3 Slide the wheel (1.2) onto the axle, put on the washer (1.3) and complete by pushing
the split pin (1.4) through the hole in the end of the axle and bending over to retain.
4.4 Repeat for the other side.
4. ASSEMBLY
fig 1
Model No: .....................................CST988.V3
Max. Load: .............................................250kg
Wheel Diameter: ................................. 250mm
Wheel Thickness: ................................. 90mm
Height: .............................................. 1260mm
Overall Width: ..................................... 560mm
Platform Depth:. ................................. 220mm
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
VST988_V3 Issue: 1 - 25/10/12
01284 757500
01284 703534
[email protected]
www.sealey.co.uk
email
© Jack Sealey Limited
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or phone 01284 757500.
INSTRUCTIONS FOR:
SACK TRUCK WITH PNEUMATIC
TYRES 250kg
MODEL No: CST988.V3