Sealey SACV42755B - Manual (Page 5)

7. TROUBLE SHOOTING
Fault Cause Remedy
Pressure drop in the tank. Air leaks at connections. Run compressor to max. pressure, switch off.
Brush soap solution over connections and look for
bubbles. Tighten connections showing leaks.
If problem persists contact Authorised Service Agent.
Pressure switch valve leaks when compressor is idle. Non-return valve seal defective. Discharge all tank pressure. Referring to fig.6,
unscrew valve cap 'A'. Clean rubber disc 'B' and its
seat. Refit all parts accurately.
Compressor stops and does not restart. Power failure.
Motor failure.
Check electricity supply and fuse.
Contact Authorised Service Agent.
Compressor does not stop at max pressure. Pressure switch fault. Contact Authorised Service Agent.
Compressor does not reach max pressure. Filter clogged.
Head gasket or valve fault.
Replace filter element.
Contact Authorised Service Agent.
Compressor noisy with metallic knock. Low oil level.
Bearing or piston damage.
Turn off and top up oil immediately.
Contact Authorised Service Agent.
IMPORTANT WARNING - Air contaminants taken into the compressor will affect optimum performance.
Example: Body filler dust or paint over-spray will clog the pump intake filter and may cause internal
damage to pump/motor components.
Please note that any parts damaged by any type of contamination will not be covered by warranty.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
WEEE Regulations
Dispose of this product at the end of its working life in compliance with the EU Directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or telephone 01284 757500.
Original Language Version © Jack Sealey Limited
SACV42755B,ASACV45775B Issue: 1 - 17/12/14