Electrolux Wave-Touch 137023200 A - Manual (Page 30)

30
Setting Preferences, con’t
SYSTEM CLEAN
To clean and freshen the washer, perform the
SYS-
TEM CLEAN cycle. If you wish to begin the cycle,
press
select when prompted. The next screen
will instruct you to remove all items from the wash
drum, fill the bleach dispenser and press
start.
This maintenance cycle uses hot water and two
rinses to remove residue that may cause odor.
Operating User Interface Features
RESET
Press the buttons indicated to restore only cycle
settings, reset only factory preferences (users,
language, brightness, volume, etc.) or restore
all factory defaults (both cycle settings and fac-
tory preferences). Press the button under
EXIT
to return to normal operation or press the cancel
button to turn the washer off without making any
changes. If you do not make a selection within 30
seconds the washer will return to normal opera-
tion without any changes. If you reset all settings,
INSTALL CYCLE will be displayed as though the
washer were just turned on for the first time. You
may press the button under
CANCEL if you do not
wish to rerun the INSTALL CYCLE.
CONTRAST
Press the button beneath plus (+) or minus (-)
symbols to increase or decrease the contrast of
the display. Press
select to accept the change or
press the button under EXIT to return to normal
operation without any changes.
NOTE
The washer will automatically prompt you to run
the
SYSTEM CLEAN cycle every 50 cycles. You
may press the button under EXIT to manually
perform the cycle at another time.