Electrolux Wave-Touch 137023200 A - Manual (Page 29)

29
Operating User Interface Features
Setting Preferences, con’t
INSTALL CYCLE
Run the INSTALL CYCLE before operating the
washer the first time. Remove all items from the
washer drum and press
start. For more informa-
tion on performing the washer INSTALL CYCLE,
refer to the Installation Instructions accompanying
this washer.
If the washer has been installed according to
Installation Instructions,
INSTALL PASSED -
DOOR CAN BE OPENED will be displayed and
the washer is ready to use.
If the washer was not installed properly, NO WATER -
OPEN WATER VALVES , WATER HOSES - CHECK
WATER HOSES or CALL SERVICE 877 435
3287 will be displayed to indicate the installation
error.
The errors may result from the following condi-
tions:
NO WATER • —Water inlet hoses have not been
attached to water supply or water supply valves
have not been turned on. Install hoses correctly
and turn on water supply valves.
CHECK HOSES • —The hot inlet hose may have
been connected to the cold water supply and
the cold inlet hose may have been connected
to the hot water supply. Check hoses for cor-
rect supply connection. If incorrect, disconnect
hoses and connect to correct inlets according to
Installation Instructions.
CALL SERVICE 877 435 3287 • —Error can
only be corrected by calling a qualified techni-
cian (1-877-435-3287).
Repeat the INSTALL CYCLE when corrections are
completed.
NOTE
The INSTALL CYCLE is prompted automatically
only once when the washer is turned on the first
time at the end of installation. After that, if you
wish to run a subsequent
INSTALL CYCLE when
moving the washer or modifying your installation,
you may perform your own
INSTALL CYCLE
by selecting it in the set prefs feature and then
following the screen prompts.