Energizer PORTABLE GAS DETECTION INSTRUMENT User Manual

Page 5

3.0 GENERAL INSTRUCTIONS
3.1 UNPACKING
Remove the SCOTT INSTRUMENTS MINI-SA instrument from its packaging
and examine it for external damage. If any damage is found, notify your
SCOTT INSTRUMENTS distributor, sales representative, or the SCOTT IN-
STRUMENTS Service Department.
3.2 REGISTRATION
Fill out and mail the postage paid Registration Card provided. Registering
your SCOTT INSTRUMENTS MINI-SA instrument assures that you will re-
ceive notification of any future enhancements and/or upgrades that become
available. You may also register your instrument on SCOTT INSTRUMENTS
web site “www.scottinstruments.com”.
3.3 BATTERY INSTALLATION
The SCOTT INSTRUMENTS MINI-SA instrument is powered by two “AAA”
Alkaline batteries. Use only alkaline (Eveready Energizer Industrial EN 92,
Duracell PC2400, or Ray-O-Vac AL-AAA) batteries. Use of any other batter-
ies except those listed will void the intrinsic safety listing of the SCOTT
INSTRUMENTS MINI-SA Portable Gas Detector. Use of rechargeable batter-
ies is prohibited. Two of the specified “AAA” Alkaline batteries will provide
approximately one hundred (100) hours of continuous non-alarming opera-
tion before requiring replacement.
Install the batteries as follows:
1) Remove the battery cover by loosening the #1-phillips-head captive cover

screw counterclockwise, then lifting the cover out of the housing. Then
lift the two batteries from the housing, using a small coin or tool.

2) Install two (2) AAA Alkaline batteries of the specified type. Note polarity

orientation (+/-) as shown inside the battery box and push the batteries
securely in between the contacts.

3) Replace the battery cover by pushing it into the bottom detents and

secure by tightening the cover screw.

NOTE

The metal belt clip is designed to be removed from the instrument. After
removing the battery cover, remove the cover screw completely and slide
the clip out of the cover. Store the clip for future use. Replace the cover
screw and reattach battery cover to the instrument.