Ultimate Speed UOP 12 A1 - Manual (Page 35)

32 UOP 12 A1
GB
MT
♦ Place the on/off switch 2 at the position 0 (Off ) when no more oil fl ows
from the engine/the oil sump. Do not leave the oil suction pump running
if it is not pumping oil.
♦ Do not let the oil suction pump run for longer than 30 minutes at a time.
♦ Refi ll the engine with fresh oil as directed in your vehicle manufacturer's
instructions. Check the oil level with the dipstick.
♦ Clean the oil suction pump after the job is done by pumping a little fresh oil
through it.
♦ Dispose of the used oil as per the statutory regulations in your country
(see also the chapter Disposal).
♦ Loosen the hose clamps 9 and remove the suction hose (Ø 6 mm) 7 and
the discharge hose (Ø 12 mm) 8 from the oil suction pump. Store all parts
at a dry, clean and dust-free location.
Cleaning
TAKE NOTE
Damage to the device!
► In order to avoid irreparable damage to it, ensure that no moisture gets
inside when you are cleaning the device.
Cleaning the housing
♦ Clean the oil suction pump after every job is done by pumping a little fresh
oil through it.
♦ Clean the connection terminals after each pumping. Wipe off any possibly
present battery fl uid on the connection terminals with a dry cloth so as to
protect them from corrosion.
♦ Clean the surfaces of the device and the hoses with a soft, dry cloth.
Maintenance
♦ Before every use, check the device for visible external damage.
♦ Check the cable before each use for damage.
♦ Check the hose clamps 9 for fi rm seating.
♦ Before every use, check the insulation of the connection terminals 3 + 4 .
IB_102790_UOP12A1_LB5.indb 32 IB_102790_UOP12A1_LB5.indb 32 25.08.14 11:29 25.08.14 11:29