Ultimate Speed ALUMINIUM JUMP LEADS – 25mm - Manual (Page 3)

7 GB/IE
Using the jump lead / Care and maintenance / Guarantee and service
Note: The parts should be as far away as possi-
ble form the starter battery in order to prevent any
explosive gas that may develop from being ignited.
RISK OF EXPLOSION! On no
account should you connect the
negative pole to the flat battery as
there is a risk that sparks may fly and ignite
explosive gases.
Q Starting
After you have connected the jump leads, first
switch on the engine of the vehicle with the do-
nor battery (car B). Then start the motor of the
broken-down vehicle (car A).
Note: After every attempt to start the car – which
should not be longer than 15 seconds – wait for at
least 1 minute. If you cannot start the car after sev-
eral attempts, contact a garage.
After successfully starting the broken-down
vehicle (car A) wait for 2 to 3 minutes until the
engine is running smoothly.
Q Disconnecting
Note: When the motor has started, switch on the
electric consumers, e.g. car lights or rear window
heating, in order to prevent voltage peaks.
Note: Disconnect the jump leads in the reverse
order to the way they were connected.
1. Remove the pole terminal 4 of the black jump
lead 3 from the vehicle chassis of the broken-
down car (A).
2. Then disconnect the other pole terminal 4 of
the black jump lead 3 from the negative pole
of the donor battery (B).
3. and 4. Remove the two pole terminals 2 of the
red jump lead 1 in any order you wish (A, B).
When removing the jump leads, make sure that
they do not come into contact with the moving
parts of the engine.
Note: Do not switch the vehicle that has been
jump started off immediately. Drive the vehicle
around for a while so that the battery is recharged
by the alternator.
Q Care and maintenance
DANGER TO LIFE FROM
ELECTRIC SHOCK! For reasons of electrical
safety, the jump lead may never be cleaned with
water or other fluids and never be immersed
into water.
After using the jump lead, always store it in the
storage bag it came in to protect the product
from damp and dirt.
Note: The jump lead should always be carried
safely in the vehicle.
J Do not use solvents, petrol etc.
Use a dry fluff-free cloth when you are cleaning.
Q Guarantee and service
Q Guarantee declaration
This product comes with a three-year guarantee.
Please keep your receipt as proof of purchase. The
product has been produced to the highest standards
and thoroughly checked before dispatch. The guar-
antee only applies to faults in material or manufac-
ture when used properly. The guarantee lapses in
cases of unauthorized tampering. This guarantee
does not restrict your legal rights. In case of a war-
ranty claim, please contact the service centre by
phone.
Q Service
+49 / (0) 721 / 625 28 – 866
66824_uls_Starthilfekabel Alu_Content_LB3.indd 7 20.06.11 12:40