Ultimate Speed UAMM 12 A1 - Manual (Page 8)

6
3. Plug the mains adapter 3 into a mains
socket that complies with the technical
data.
4. Plug the power plug 2 on the mains
adapter 3 into the power socket 6 .
5. Operation
The remote control has background
illumination. If this does not come on, the
background illumination will be switched on
first when button
11 , 12 or 13 is pressed for
the first time. Only when the background
illumination is on does the button have the
function described below. The background
illumination goes off again after about 5
seconds.
If you press the OFF button
10 , the device
switches off immediately.
5.1 Switching the device on and off
1. To switch the device on, press the ON
button 12 .
The LCD display 9 shows "MODE 0”.
2. To switch the device off, press the OFF
button 10 .
5.2 Selecting a programme
There are 8 programmes (MODE 1 – 8)
available altogether. The programmes vary
in their intensity, the area massaged and the
massage rhythm.
1. Press the MODE programme button
11 .
The device switches to the next
programme and the motors start to
work. The selected programme number
is shown in the LCD display
9 .
The timer counts down the minutes,
beginning at 30 minutes.
The remaining time is shown in the LCD
display
9 .
As soon as the 30 minutes have expired,
the device switches off automatically.
5.3 Switching the heater on and off
1. To switch the heater on, press the heat
button 13 .
Heat will now be produced from inside
the massage mat.
The timer continues to count down the
time (see “5.1 Switching the device on
and off” on page
6). The heating
function does not affect the timer.
The heater switches off automatically
after about 30 minutes.
2. To switch the heater off, press the heat
button 13 again.
RP69011 Automassage SB1 Seite 6 Freitag, 12. August 2011 9:50 09