Extron electronic P/2 DA Series - Manual (Page 3)

Specifications are subject to change without notice.
specifications
VIDEO
Gain
P/2 DA4/6 xi ....................................... 0 dB or +3 dB (when input is 0.7 Vp-p, output is
0.7 V or 1.0 V), switchable
P/2 DA8/12 Series ............................... Unity
Bandwidth ..............................................350 MHz (-3 dB), fully loaded
VIDEO Input
Number/signal type ................................ 1 VGA-QXGA RGBHV, RGBS, RGsB, RsGsBs, HDTV
component video, S-video, composite video
Nominal level ......................................... 1.0 Vp-p for Y of component video and S-video,
and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of
component video
0.3 Vp-p for C of S-video
Minimum/maximum levels ..................... Analog: 0.3 V to 1.5 Vp-p with no offset at unity
gain
Impedance ............................................. 75 ohms
Horizontal frequency............................... 15 kHz to 135 kHz
Vertical frequency ................................... 30 Hz to 150 Hz
Return loss .............................................. <-40 dB @ 5 MHz
Input coupling ........................................ DC
VIDEO Output
Number/signal type ................................ 4, 6, 8, or 12 (depending on model) VGA-QXGA
RGBHV, RGBS, RGsB, RsGsBs, HDTV component
video, S-video, composite video (follows input
type)
Connectors ............................................. 4, 6, 8, or 12 female 15-pin HD
Nominal level ......................................... 1.0 Vp-p for Y of component video and S-video,
and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of
component video
0.3 Vp-p for C of S-video
Minimum/maximum levels ..................... 0.3 V to 1.5 Vp-p (follows input)
Return loss .............................................. <-40 dB @ 5 MHz
DC offset ................................................ ±5 mV with input at 0 offset
Sync
Input type ............................................... RGBHV, RGBS, RGsB, RsGsBs; bi-level and tri-level
sync
Output type
P/2 DA4/6 xi ....................................... RGBHV, RGBS, RGsB, RsGsBs; bi-level and tri-level
sync (follows input)
P/2 DA8/12 Series ............................... RGBHV, RGBS, RGsB, RsGsBs; bi-level and tri-level
sync (follows input)
Tri-level on Y, R-Y, B-Y channels (component video
720p, 1080i, 1080p)
Bi-level on Y channel (for all other component
video rates)
Input level............................................... 2.0 V to 5.0 Vp-p
Output level
P/2 DA4/6 xi ....................................... TTL: 5.0 Vp-p, unterminated
P/2 DA8/12 Series ............................... 0.3 Vp-p for component video (bi-level sync)
0.6 Vp-p for component video (tri-level sync)
TTL: 5.0 Vp-p, unterminated for RGBHV, RGBS
Input impedance
P/2 DA4/6 xi ....................................... 510 ohms
P/2 DA8/12 Series ............................... 10k ohms or 510 ohms (default), selectable
Output impedance
P/2 DA4/6 xi ....................................... 50 ohms
P/2 DA8/12 Series ............................... 50 ohms (default) or 75 ohms, selectable
Max. propagation delay
P/2 DA4/6 xi ....................................... 60 ns
P/2 DA8/12 Series ............................... >90 ns
Max. rise/fall time ................................... 2 ns
Polarity ................................................... Positive or negative (follows input)
AuDIO — p/2 DA8 A, p/2 DA12 A
Gain ..................................................... Unbal. output: 0 dB; bal. output: +6 dB
Frequency response ............................... 20 Hz to 20 kHz, ±0.2 dB
THD + Noise .......................................... 0.03% @ 1 kHz at nominal level
S/N ...................................................... >90 dB at maximum output (unweighted)
Crosstalk ................................................ <-45 dB @ 1 kHz
Stereo channel separation ...................... >80 dB @ 1 kHz
AuDIO Input– p/2 DA8 A, p/2 DA12 A
Impedance ............................................ >10k ohms unbalanced, DC coupled
Nominal level ......................................... -10 dBV (316 mVrms)
Maximum level ...................................... +16 dBu, (unbalanced) at 1% THD+N
0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms,
0 dBV 2 dBu
AuDIO Output – p/2 DA8 A, p/2 DA12 A
Number/signal type ............................... 8 or 12 (depending on model) stereo, bal./unbal.
Connectors ............................................. (8) or (12) 3.5 mm captive screw connectors,
5 pole
Impedance ............................................ 50 ohms unbal., 100 ohms bal.
Gain error .............................................. ±0.1 dB channel to channel
Maximum level (Hi-Z) ............................ >+28 dBu, bal., >+20 dBV unbal. at 1% THD+N
Maximum level (600 ohm) .................... >+21 dBm, bal., >+18 dBm unbal. at 1% THD+N
cOntrOl/rEmOtE – p/2 DA8 Series, p/2 DA12 Series
Contact closure mute control .................. (2) 3.5 mm captive screw connectors, 4 pole and
(2) 3.5 mm captive screw connectors, 3 pole
Contact closure pin configurations
P/2 DA8 Series ........................................ A = mute all outputs, 1 = mute output 1,
2 = mute output 2, 3 = mute output 3,
8 = mute output 8
P/2 DA12 Series ...................................... A = mute all outputs, 1 = mute output 1,
2 = mute output 2, 3 = mute output 3,
12 = mute output 12
GEnErAl
Power
P/2 DA4/6 xi ....................................... 100 VAC to 240 VAC, 50/60 Hz, 12 watts, internal
P/2 DA8/12 Series ............................... 100 VAC to 240 VAC, 50/60 Hz, 30 watts, internal
Cooling................................................... Convection, no vents
Mounting - Rack mount
P/2 DA4/6 xi ....................................... Yes, with optional 1U, 9.5" deep rack shelf
(RSU 129, part #60-190-01; RSB 129, 60-604-01);
or 1U, 6” deep rack shelf (RSU 126, #60-190-10;
RSB 126, 60-604-10)
P/2 DA8/12 Series ............................... Yes, with included brackets, MBD 149, part
#70-077-03
Furniture mount
P/2 DA4/6 xi ....................................... Yes, with optional under-desk mounting kit,
part #70-077-01 (MBU 125); or through-desk
mounting kit, part #70-077-02 (MBD 129)
P/2 DA8/12 Series ............................... Yes, with optional under-desk mounting kit
MBU 149, part #70-222-01
Enclosure dimensions
P/2 DA4/6 xi ....................................... 1.6" H x 8.7" W x 6.0" D (1U high, half rack wide)
(4.1 cm H x 22.1 cm W x 15.2 cm D)(Depth
excludes connectors.)
P/2 DA8/12 Series ............................... 1.7" H x 17.4" W x 8.5" D (1U high, full rack wide)
(4.3 cm H x 44.2 cm W x 21.6 cm D) (Depth
excludes connectors.)
Product weight
P/2 DA4/6 xi ....................................... 2.0 lbs (0.9 kg)
P/2 DA8/12 Series ............................... 6.0 lbs (2.7 kg)
Shipping weight
P/2 DA4xi ............................................ 4 lbs (2 kg)
P/2 DA6xi ............................................ 5 lbs (3 kg)
P/2 DA8/12 Series ............................... 9 lbs (5 kg)
DIM weight (P/2 DA8/12 Series)
USA/Canada ........................................... 10 lbs (5 kg)
International ........................................... 11 lbs (5 kg)
Listings ................................................... UL, CUL
Compliances ........................................... CE, FCC Class A, VCCI, AS/NZS, ICES
NOTE: All nominal levels are at ±10%.
Model Version Description Part Number
P/2 DA4xi 1x4 VGA-QXGA ...................................................... 60-246-03
P/2 DA6xi 1x6 VGA-QXGA ...................................................... 60-245-03
P/2 DA8 A 1x8 VGA-QXGA with Audio ..................................... 60-891-01
P/2 DA8 1x8 VGA-QXGA ...................................................... 60-891-02
P/2 DA12 A 1x12 VGA-QXGA with Audio .................................. 60-893-01
P/2 DA12 1x12 VGA-QXGA ................................................... 60-893-02