Elite Screens 235 - Manual (Page 8)

8
Rev.051811‐AS
www.elitescreens.com [email protected]
3. Slide the top end of the bar into the top center point location to complete the installation. This will
provide stability to the frame and tension to the material.
Installation
1. Elite recommends using a stud finder (not included) to locate and mark the installation location.
2. Drill a hole with the proper bit size according to the included wood screws.
3. Line‐up the Wall Brackets with the drilled holes and screw them in using a Phillips screw driver.
Note: 2 wall brackets are provided with diagonal sizes below 135”, and 3 for diagonal sizes 135” and above.
4. Position the frame onto the top wall brackets (see fig.9) and push down at the center of the bottom
frame to secure the installation.
5. The wall brackets provide flexibility by allowing the frame to slide to the sides. This feature allows the
screen to be properly centered.
Center Support Bar
(Fig. 8)
Wall brackets
2 pcs
(fig. 9)