Florabest FGS 3.6 A1 - Manual (Page 15)

15
GB
with the local regulations. Take the
equipment to a collection point, where
it will be recycled in an environmentally
friendly manner. For information about
this, ask your local waste management
company or our service centre.
• Defective units returned to us will be
disposed of for free.
• Place cut branches in compost and not
in the dustbin.
Telescopic arm as an
accessory
Ensure that the safety key ( 7) is
removed before all tasks.
Device is delivered without a telescop-
ic arm. Alternatively, a telescopic arm
including wheels can be ordered (see
“Spare parts/accessories”).
Assembling the telescopic arm
Putting the telescopic arm
together:
1. Put both parts of the telescopic
arm (18) together and tighten the
screw.
Make sure that the cable is not
clamped.
Assembling/dismantling
the telescopic arm:
2. Push the device along the guide
rail (19) into the equipment
holder (20) of the telescopic arm.
It locks into place audibly.
3. Plug the plug connection (21) into
the charging socket (5) on the
back of the equipment handle (4).
4. To dismantle, release the plug
connection (21). Press the unlock
button on the bottom side of the
equipment holder (20) of the
telescopic arm and pull the device
out (see small image).
Adjust the height of the tel-
escopic arm
Adjust the length of the telescopic arm
for your size with the help of the ad-
justing screw (22).
Adjusting the working angle
For a comfortable edge cut, the equipment
holder (20) of the telescopic arm can be ro-
tated to the right or left (90 °).
Set the desired position by pulling
the release switch (23) and rotating
the equipment holder (20) of the tel-
escopic arm. The equipment holder
locks into the desired position when
the release switch is released.
Switching on and off
(with telescopic arm)
1. Remove the blade guard (
11/14) before switching the de-
vice on.
2. Insert the safety key ( 7) into the
device.
3. To switch on, hold the switch lock (24)
on the handle of the telescopic arm
and simultaneously press the on/off
switch (25). Release the switch lock,
device runs at top speed.
4. To turn it off, release the on/off
switch (25).
Working with the telescopic arm
• Slowly push the device on the wheels
over the floor. By doing so, you will
achieve an even cutting height.