Florabest FGS 3.6 A1 - Manual (Page 68)

68
GB
Telescopic arm as an
accessory
Ensure that the safety key ( 7) is
removed before all tasks.
Caution! Device is delivered with-
out a telescopic arm. Alternatively,
a telescopic arm including wheels
can be ordered (see “Spare parts/
accessories”).
Assembling the telescopic
arm
Putting the telescopic arm
together:
1. Put both parts of the telescopic
arm (18) together and tighten
the screw.
Make sure that the cable is not
clamped.
Assembling/dismantling
the telescopic arm:
2. Push the device along the guide
rail (19) into the equipment hold-
er (20) of the telescopic arm. It
locks into place audibly.
3. Plug the plug connection (21)
into the charging socket (5) on
the back of the equipment han-
dle (4).
4. To dismantle, release the plug
connection (21). Press the unlock
button on the bottom side of the
equipment holder (20) of the tel-
escopic arm and pull the device
out (see small image).
Adjust the height of the tel-
escopic arm
Adjust the length of the telescopic
arm for your size with the help of
the adjusting screw (22).
Adjusting the working angle
For a comfortable edge cut, the equipment
holder (20) of the telescopic arm can be
rotated to the right or left (90 °).
Set the desired position by pulling
the release switch (23) and rotating
the equipment holder (20) of the tel-
escopic arm. The equipment holder
locks into the desired position when
the release switch is released.
Switching on and off
(with telescopic arm)
1. Remove the blade guard (
11/14) before switching the de-
vice on.
2. Insert the safety key ( 7) into
the device.
3. To switch on, hold the switch
lock (24) on the handle of the
telescopic arm and simultaneous-
ly press the on/off switch (25).
Release the switch lock, device
runs at top speed.
4. To turn it off, release the on/off
switch (25).
Working with the telescopic
arm
• Slowly push the device on the wheels
over the floor. By doing so, you will
achieve an even cutting height.