Florabest FSG 85 B1 - Manual (Page 56)

56
GB MT
erwise damaged grinding disks.
- Switch on the equipment only
when it is safely installed on the
work surface.
Risk of injury!
Wear ear, eye and hand protection!
When working with the saw chain,
wear cut resistant gloves and an
apron if necessary, to avoid inci-
sion injuries.
Keep hands away from the grinding
disk and chain teeth when the equip-
ment is in use. Do not move the chain
by hand. There is a risk of injury.
Switching on and off
Ensure that the mains voltage
matches the specifications on the
rating plate.
Connect the equipment to the mains.
1. To switch on, press the “I” On switch
(green) and the device starts up (see
1a).
2. To switch off, press the “0” Off switch
(red) and the device switches off (see
1b).
The disk will continue to
run after the equipment is
switched off. There is a risk
of injury.
Protection against overheating and
restart:
The unit will not automatically restart follow-
ing an automatic cutout due to overload.
To restart the grinder, press the “I” On switch
(green) and the device starts up (see 1a).
Test run:
Before starting work and after each
change of grinding disk, carry out a test
run of at least 30 seconds with no load.
Switch off the equipment immediately if the
disk runs lumpy, substantial vibrations oc-
cur, or abnormal noises are generated.
Sharpening the saw chain
When working with the saw chain,
keep clean the ventilation openings
(see “Maintenance and cleaning”).
In case of a blockage, switch off
the equipment and disconnect from
the mains. Only then should the
blockage be removed.
An incorrectly sharpened
saw chain may damage the
chain the increase the risk of
the saw jumping back.
Ensure that the chain is
aligned accurately.
Observe the correct rake an-
gle and minimum dimensions
of the saw chain. Remove as
little material as possible.
Do not grind in
drive (a) or con-
necting (b) links,
otherwise the saw
chain may rupture.
In the event of non-obser-
vance, there is a risk of acci-
dents when handling the
chainsaw.
Instructions for sharpening
• Clean the saw chain before you sharp-
en it. Use a brush or cloth to remove
oily wood chips or residual oil.