Florabest FHEHS 900 A1 - Manual (Page 12)

8
FHEHS 900 A1
GB
Tightening and checking the saw chain
WARNING!
► Wear protective gloves! There is a danger of injury from the sharp
cutting teeth.
♦ Turn the chain tensioner screw with the mounting tool in a clock-
wise direction to increase the tension.
♦ The saw chain must lie against the underside of the blade. Check
whether the saw chain can be drawn by hand over the blade .
NOTE
► A new saw chain stretches and must be tightened more regularly.
Lubricating the chain
♦ Remove the oil fi ller cap .
♦ Fill the oil tank with approx. 100 ml of organic chain oil .
WARNING!
► Never work without chain lubrication!
If the saw chain runs dry, the cutting equipment may become irre-
parably damaged in a short time. Always check chain lubrication
and oil level in the tank before starting work.
NOTE
► Use only saw chain oil. Preferably biodegradable. Do not use waste
oil, motor oil, etc.
► While working, check whether the automatic chain lubrication is
working correctly. Check the chain lubricator before and during
work.
Sharpening the saw chain
NOTE
► A grinder can be attached to the grinder support for a secure
grip during grinding.
► You will fi nd detailed information on sharpening in the sharpening
set, e.g. from Oregon.
► Alternatively, you can use an electrical saw chain sharpening device
and follow the instructions of the manufacturer.
► If you have any doubts about implementing the work, the saw chain
should be replaced.
Initial use
NOTE
► Comply with regulations regarding noise protection and local rules.
Using the appliance on certain days (e.g. on Sundays and public
holidays), during certain times (midday period, night time) or in certain
locations (e.g. health resorts, clinics, etc.) may be restricted or
prohibited.
Switching on and off
Switching on:
♦ Connect the power cord to the extension cable.
♦ Form a loop at the end of the extension cable and attach this to the
strain relief .
♦ Press the safety lock-out and keep it pressed and then press the
on/off switch .
Switching off :
♦ Release the on/off switch .
♦ Remove the extension cable from the strain relief .
♦ Disconnect the power cord from the extension cable.
Adjusting the handle
♦ Press the release button .
♦ Turn the turning element to the desired position. Let go of the release
button ; this must click into place.
Working with the hedge trimmer
Cutting techniques
■ See fold-out page (Figure A).
NOTE
► Remove thicker branches with a branch cutter.
Working with the pole pruner
Sawing techniques
WARNING!
► Pay attention to falling clippings.
► Be aware of the danger of branches fl ying back.
NOTE
► Place the stop on the branch. This will help you work more safely
and quietly.
► Only then can you begin with the sawing.
Sawing off small branches
♦ Saw small branches (Ø 0–8 cm) from the top down (see fi gure).
IB_102878_FHEHS900A1_LB4.indb 8 14.11.14 08:24