Florabest FGH 710 A1 - Manual (Page 11)

11
GB
(18). Release the safety release
catch (17).
The tines ( A 11) will begin to
rotate and dig themselves into
the earth.
6. To switch off, release the dead-
man lever (18).
Warning! The tines will con-
tinue to turn for a few sec-
onds after the tool has been
switched off. Do not touch
the rotating tines – injury
hazard!
Operating instructions
Always keep a firm grip on
the tool with booth hands
and watch your feet.
The tines (11) may cause an
accident. Be careful while
moving backwards – danger
of tripping!
Do not touch the gearbox, as
it may become hot during op-
eration – danger of burns!
Switch the tool off after working
with it and for transport; disconnect
from the mains and wait for the
tines to stop moving.
To avoid damage to the
tool:
• Never lift or drag the tool with
the motor running.
• Lift the tool while moving it over
hard surfaces such as tiles or
steps.
• Walk the tool through the soil
at normal pace and in a line as
straight as possible.
• Always work away from the
mains socket. Make sure that
the cable is kept well away from
the working area. Hanging the
cable into the belt clip included
in the package will help.
Overload protection: The motor
will cut out immediately if overload-
ed. The tool cannot be used until it
has completely cooled down again.
Cleaning/Maintenance
Always return the tool to the service
centre for work not described in the
manual. Only use original parts.
Switch the tool off, unplug it from
the mains, and wait for the tines
(11) to stop moving before carrying
out any maintenance or cleaning
work on the tool.
Perform regular maintenance and cleaning
on the tool. This will ensure long, reliable
service.
General cleaning and
maintenance work
Do not spray the tool down
with water (especially not
under pressure), and do not
clean it under running water.
Wear protective gloves when carry-
ing out maintenance and cleaning
work on the tool to avoid injury
from cuts.
Always clean the tool thoroughly after
each use. Always keep the tool clean. Do
not use cleaning fluids or solvents.