Epson RS830 - Manual (Page 10)

10
ATTACHINg THE LEgS TO THE SAW BASE
1. Loosen the lock knob (A) Fig. 1, and move the cutting-head (B) to the rear position. Tighten the knob (A).
Clamp the cuttinghead at the back of the track arm securely.
2. Place the radial arm saw on its back. Use sixteen 5/16-18 x 5/8" carriage head screws to attach the legs (C) Fig. 2 (three of
which are shown attached) to each corner of saw base (D). Place the screws through the stand, then use a flat washer, a
lock washer, and a nut to secure them. Hand tighten the nuts.
3. Stand the saw in the upright position and securely tighten all stand hardware.
ATTACHINg THE WRENCH HOOK
Attach the wrench hook (K) Fig. 3 to the front
right or back left side of saw base (D), using two
#10 x 1/2" sheet metal screws.
Fig. 1 Fig. 2
Fig. 3
B
A
C
C
C
C d
d
K
REMOVINg THE BLAdE ANd BLAdE gUARd FROM THE SAW
1. Loosen the blade guard clamp knob (A) Fig. 4 and rotate the blade guard (B) to the position shown.
2. Use the wrenches (C) Fig. 5 to loosen the arbor nut (D).
NOTE: Arbor nut has left-hand threads.
Fig. 4
B
Fig. 5
A
B
F
d
C
g
To reduce the risk of injury, turn unit off and disconnect machine from power source before installing and
removing accessories, before adjusting or changing set-ups or when making repairs. An accidental start-up can cause
injury.