Florabest FRM 1800 B2 - Manual (Page 27)

27
MT GB
Trouble Shooting
Problem Possible Cause Fault Fixing
Equipment does
not start
Power is off
Check the socket, cable, wire
and plug and have any repairs
carried out by an electrician
Defective start lever
( A 15)
Repair by customer services
Worn carbon brushes
Defective motor
Grass too long
Set a greater cut height. Lift the
front wheels slightly by pressing
down on the handle bar.
Motor stops
Blockage by foreign
object
Remove the foreign object
Result
unsatisfactory or
motor labours
Cut height too low Set a higher cut height
Blade (
I
23) blunt
Have the blade (
I
23)
sharpened or replace it
Blade (
I
23) area
blocked
Clean the equipment
Blade ( I 23)
assembled incorrectly
Install the blade ( I 23) correctly
Blade (
I
23)
fails to turn
Blade ( I 23) blocked
by grass
Remove the grass
Blade screw (
I
22)
loose
Tighten the blade screw ( I 22)
Strange noises,
rattling or
vibrations
Blade screw ( I 22)
loose
Tighten the blade screw ( I 22)
Blade ( I 23)
damaged
Replace the blade ( I 23)
Level indicator
( E 21) does not
work
Contamination
Cleaning with a soft brush. The
level indicator must close by
itself, if it was opened.
Changing the Blade
If the blade is blunt, it can be sharpened
by a specialist workshop. If the blade is
damaged or showing signs of imbalance,
it must be replaced (see chapter on “Spare
Parts”).
I
1. Switch off the equipment, discon-
nect the plug and wait until the
blade stops.
2. Turn the equipment over.
3. Use sturdy gloves and hold the
blade firmly (23). Turn the blade
screw (22) anticlockwise off of
the motor spindle (24) using a
screwdriver (A/F width13).
4. Install the new blade in the
reverse order. Ensure that the
blade is positioned correctly and
the screw tightened firmly.
Storage
• Keep the equipment dry and out of
reach of children. Loosen the wing nuts
and fold down the handle bar so the
equipment takes up less space. Ensure
that the cable is not caught.
• Allow the motor to cool before storing
the equipment in a confined space.
• Do not cover the equipment with nylon
bags as moisture could build up.
We will not be liable for damages caused
by our equipment where these are caused
by improper repair or the use of non-
original parts or by use other than for the
intended purpose.
Waste disposal
and environmental
protection
Do not dispose of used oil in the sewage
system or drains. Dispose of used oil in an
environmentally correct manner - bring it to
a waste disposal center.
Be environmentally friendly. Return the
tool, accessories and packaging to a
recycling centre when you have finished
with them.
Machines do not belong with do-
mestic waste.
The plastic and metal parts employed can
be separated out and thus recycled use
can be implemented. Ask our Service-
Center for details.
Replacement parts / Accessories
Spare parts and accessories can be obtained at
www.grizzly-service.eu
If you do not have internet access, please contact the Service Centre via telephone (see
“Sercice-Center” Page 29). Please have the order number mentioned below ready.
Item Description .......................................................... Product No.
4 Grass bag ......................................................................... 91103875
I
23 Spare blade ...................................................................... 13700303