beautypg.com

Operation – Florabest FAT 18 B3 User Manual

Page 14

background image

14

GB

To insert the battery:

5. To insert the battery (16), place it

on the guide track (20) and push

it into the appliance. It will audi-

bly snap in.

Operation

Caution: risk of injury! Do not

operate the appliance with-

out the protective cover. To

operate the appliance, wear

suitable clothing, eye and ear

protection.

Prior to every use, check that

the appliance is operative. Do

not block the On/Off switch

or the switch lock. They must

reliably turn off the motor

when you release the switch.

Do not operate the appliance

if one of the switches is dam-

aged.

Please observe local regulations

concerning noise protection.

Turning on and off

Maintain a firm stand and hold the

appliance well with both hands and

at some distance away from your

body. Before turning on the appli-

ance, check that it will not touch

any objects.

1. Check that the battery (16) is in

(see “Assembly instructions - In-

serting the battery”).

2. To turn on, use your thumb to

actuate the switch lock (3), then

press the On/Off switch (2). Re-

lease the switch lock.

3. To turn off, release the On/Off

switch (2). There is no continuous

operation mode.

After turning off the appli-

ance, the trimming assembly

will keep revolving for some

time. Allow the trimming as-

sembly to come to a stand-

still. Neither touch nor slow

down the moving cutting in-

sert. Risk of injury!

Checking the battery charge

level

The battery’s ( 18) charge level is indi-

cated by the charge state indicator (

16).

Press the PRESS button on the battery.

The LEDs indicate the battery’s charge

level.

one green LED = battery low

two green LED = charging about half

three green LED = battery fully charged

red LED

= charging the battery

Trimmer settings

To adjust the auxiliary handle:

The auxiliary handle can be set to various

positions. Adjust the handle such that the

cutting disk slightly tilts forward in your

working position.



Loosen the screw (23) in the handle

and move the auxiliary handle (5) to

your favourite position. Tighten the

screw in the handle.