Florabest FHE 550 B2 - Manual (Page 9)

9
GB
changing.accessories,.or.storing.
power.tools. Such preventive safety
measures reduce the risk of starting the
power tool accidentaIly.
• Store.idle.power.tools.out.of.the.
reach.of.children.and.do.not.al-
low.persons.unfamiliar.with.the.
power.tool.or.these.instructions.
to.operate.the.power.tool. Power
tools are dangerous in the hands of un-
trained users.
• Maintain.power.tools..Check.for.
misalignment.or.binding.of.mov-
ing.parts,.breakage.of.parts.and.
any.other.condition.that.may.af-
fect.the.power.tool’s.operation..
If.damaged,.have.the.power.
tool.repaired.before.use. Many
accidents are caused by poorly main-
tained power tools.
• Keep.cutting.tools.sharp.and.
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
• Use.the.power.tool,.accessories.
and.tool.bits.etc..in.accordance.
with.these.instructions,.tak-
ing.into.account.the.working.
conditions.and.the.work.to.be.
performed..Use of the power tool for
operations different from those intended
could result in a hazardous situation.
• Carefully inspect the area to be cut and
remove all wires or other foreign bod-
ies.
Service.
• Have.your.power.tool.serviced.
by.a.qualified.repair.person.us-
ing.only.identical.replacement.
parts. This will ensure that the safety of
the power tool is maintained.
Further safety directions
• This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been
given supervision or instruction concern-
ing use of the appliance by a person
responsible for their safety.
• Children must be supervised in order
to ensure that they do not play with the
equipment.
• Damaged cables, coupling and plugs
or connecting leads, not corresponding
to the specifications, must be not be em-
ployed. Remove the plug immediately
from the plug socket in case of damage
or cutting through of the mains cable.
• Ensure during any location change that
the saw chain is secured with the chain
brake and the chainsaw is switched off
and the finger does not contact the On/
Off switch. Carry the high pruning saw
with the chain and chain bar pointing
to the rear. Attach the chain guard for
transporting the high pruning saw.
• Never start the high pruning saw before
the chain bar, saw chain and sprocket
chain wheel covering are correctly as-
sembled.
• The high pruning saw is designed for
two-handed operation. Never work with
one hand or above shoulder height.
• Ensure you have a secure stance during
sawing. Do not work on a ladder, in the
tree or on unstable locations. Be very
cautious carrying out work on a slope.
• Basically the mains cable is dragged
behind the operator. The cable must al-
ways lead away from the high pruning
saw towards the rear.
• Keep your working area tidy. Only start
work if your working area is free from