Florabest FHE 710 A1 - Manual (Page 13)

GB
13
• The electric pruner is designed for
two-handed operation. Never work
with one hand or above shoulder
height.
• Ensure you have a secure stance dur-
ing sawing. Do not work on a ladder,
in the tree or on unstable locations. Be
very cautious carrying out work on a
slope.
• Basically the mains cable is dragged
behind the operator. The cable must
always lead away from the electric
pruner towards the rear.
• Keep your working area tidy. Only
start work if your working area is free
from obstruction and you have planned
a safe path of escape when felling tim-
ber.
• Place the claw stop securely with every
cut and do not begin with the sawing
before this.
• Be extremely careful during sawing
small bushes and branches. The thin
branch thicket can snag in the saw
and whip in your direction or make
you unbalanced.
• Do not cut wood that is lying on the
ground.
• Pay attention to a possible spring-back
during the sawing of a branch which
is under stress, if the stress force of the
wood is suddenly released. Danger of
injury exists.
• Check the safety status of the electric
pruner, in particular the chain bar,
chain brake and the chain, before use.
• In the event that the cutting attach-
ment becomes jammed or stuck in the
branches, do not attempt to free the
equipment with the use of force. Switch
off the equipment immediately and re-
start it only after clearing the blockage.
There is a risk of injury!
Fitting
• Pull out the power plug before doing
any work on the electric pruner itself
-– injury hazard!
• Alwayas wear cut-protection gloves
• Undertake only work with which you
are confident.
• In case of uncertainty, contact a spe-
cialist or contact our service directly.
Before using the electric pruner, you
must:
- assebling the round handle
- attaching and setting the shoulder strap
- fitting the blade
- fitting the saw chain
- tensioning the saw chain
- fill up with chain oil
Assembling the Round
Handle
The Allen key can be found in its
holder on the quick release (
17).
1. Detach the round handle (16)
and counter bracket (7), which
are screwed together on deliv-
ery.
2. Set round handle (16) to the de-
sired position on the telescopic
handle.
3. Place brake arm (7) on the tele-
scopic handle.
4. Screw together round handle
(16) and brake arm (7).
5. The height or holding angle of
round handle (16) can be adjust-
ed at any time by slightly loosen-
ing the screws, pushing/turning,
and retightening the screws.