Florabest FBM 575 A1 - Manual (Page 36)

ENGLISH - 7
For the purchased device you will get 3 years
guarantee.
The warranty period begins on the first sale - the
purchase must be demonstrated by a valid cash
voucher.
Our guarantee covers all serious defects of the
unit, which are proved related to material or
workmanship.
In case of a justified complaint, we are entitled
to choose to either rectify or replace the product.
In addition to the warranty period of the warranty,
the following requirements must be fulfilled:
 The device has been properly, and according
to the recommendations of the manual, used in
the private sector.
 There should have been no attempt by
purchaser or an authorized third party to repair
the unit.
Normal wear, maintenance and adjustments are
excluded from the guarantee.
Following consumable parts are excluded from
warranty:
� blade
� belt
� cables
� starter rope
� air filter
� spark plug
� other maintenance items
This warranty does not affect the existing buyer
and seller statutory warranty claims.
WARRANTY
 To remove the blade (23) unscrew the screw
(26).
 Check the conditions of the blade-support (22),
the washer (24), the key (21) and the washer
(25) and replace any parts which are damaged.
 When reassembling, make sure that the key
(21) is correctly seated in the shaft and that the
cutting edges face in the direction of the engine
rotation. The blade screw (26) must be torqued
to 5,34 Kgm (52,4 Nm).
BLADE
If the machine needs to be tilted, it should only be
with exhaust muffler facing downwards and with
as little fuel in the tank as possible.
CAUTION: Make sure engine is cold as fuel
could leak through the ventilation in the
cap and onto the exhaust muffler while
tilting machine. A hot muffler could cause
fuel to start burning.
Cleaning under the body work, see illustration
in Appendix J. With machine at a standstill and
turned off:
- Attach fitting on the deck to the water supply tap.
Turn on the tap.
- start up the motor (blade in rotation), allowing it
to warm up for a few minutes.
- at the end of cleaning switch off the engine,
turn off the tap, detach the tube from the deck
connection.
If machine is very dirty underneath, use a wooden
or plastic stick to remove grass before cleaning
with water.