Florabest FRM 1200 B3 - Manual (Page 48)

48
GB
Assembling the Grass Box
D
1. Connect the two pieces of the
collection box (16).
2. Connect the handle (15) in one
of the two pieces of the collec-
tion box (16).
Do not work with the lawn mower
without impact protection. There is
a risk of injury.
We recommend always using the
grass box when working with the
lawn mower, otherwise the mow-
ing result may be significantly im-
paired.
Operation
Hanging On / Removing the
Grass Box
E
1. To hang on the grass box (4),
lift the collision guard (7) and
hang on the grass box. Fold the
collision guard (7) onto the grass
box (4). It holds the grass box in
the correct position.
2. To remove the grass box (4),
lift the collision guard (7) and
detach the grass box. Fold the
collision guard (7) back onto the
mower housing (6).
Adjusting the Cut Height
Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
The lawn mower can be set to the follow-
ing cut heights by means of three position
changes of the front and rear wheels, ad-
justing the individual wheels:
cable from heat, oil and sharp edges.
• Switch off the equipment and discon-
nect the plug from the socket if the
power cable is damaged. If the power
cable for this equipment is damaged,
it must be replaced with a special
power cable, which is available from
the manufacturer or a customer service
agent of the same.
• Do not connect a damaged power
cable to the mains. Do not touch a
damaged power cable when it is
connected to the mains. A damaged
power cable may result in contact with
live parts.
Assembly
Disconnect the plug before any
work on the equipment. There is a
risk of injury.
Assembling the Curved Han-
dle
B 1. Insert the lower bar (3) into the
slot on the lawnmower housing
(6).
2. Fix the bar (3) using the en-
closed screws (13).
C
3. Screw all four wheels (5) onto
the lawn mower housing (6). All
of the wheels must be set to the
same height.
4. Fix the curved handle (1) using
the enclosed screws (14) and the
wing nuts (2) on the lower bar
(3). There are two possible posi-
tions.
5. Clip the cable holder (8) into the
bar (3) and thus fix the cable.
When both wing nuts are loosened,
the curved handle can be folded
down for storing the equipment.
Ensure that the power cable is not
caught.