Florabest FLB 2500 A2 - Manual (Page 57)

57
GB MT
generation of mold and unpleasant
odours.
• Free the outlet area from possible
shredded residues.
Removal of clogging and
blockage
Leaf material and fresh plant parts may
clog / block the device.
Cleaning the impeller wheel:
Pull out the mains plug!
D
1. Remove the Allen key attached
to the power cable (No. A 13)
2. Use the key (13) to open the
screw on the impeller wheel
cover (25) and tip up the cover.
3. Carefully remove residues or
clogging materials from the im-
peller wheel (24).
4. Check to make sure the impeller
wheel is easier to turn and is in
undamaged condition. Have our
Service Centre (see address on
p. 17) replace a defective impel-
ler wheel.
5. Screw the cover down tight.
The device cannot be operated
unless the impeller wheel cover
is closed and properly screwed
down.
Cleaning the air outlet area:
1. Remove the collection bag.
2. Clean the external air outlet area on
the device.
3. Set the operating mode selector
switch to the suction symbol.
4. Remove dirt residues in the inner air
outlet area with a bottle brush or simi-
lar. Remove unwieldy objects with a
blunt tool without sharp edges.
Cleaning the blower / suction tube
1. Remove the collection bag loop from
the hook.
2. Remove the fastening screws (see B
No. 4) and pull off the blower / suction
tube.
3. Knock material out of the inside of the
tube and clean it as required.
4. Remount the tube and reattach the
collection bag loop to the hook.
Replacing the collection bag
Replace a defective collection bag. Employ
only original collection bags (see chapters
“Spare Parts”), otherwise the guarantee
claim is invalid.
Safekeeping
• Keep the leaf blower in a dry, frost-free
location, which is inaccessible to chil-
dren.
• Do not store the device in direct sunlight;
store it in dark or in reduced light condi-
tions.
• Do not cover the device with nylon
bags, since moisture can form.
• Clean the device thoroughly at the
season end and for storage during
wintering. Clean the collection bag by
removing it, emptying it and washing
with warm water and neutral soap. Re-
attach the dried bag again.
• Ensure that all nuts, bolts and screws
are tightened so the equipment is in
safe, functional condition.