Florabest FLV 1300 A1 - Manual (Page 51)

51
MT GB
• Commence work in the vicinity of the
power socket and proceed away from
the socket.
• Always ensure that the extension
cable is behind you, and after turning
move it to the side that has already
been treated.
• Guide the implement at a walking
pace down lanes that are as straight
as possible. To ensure uninterrupted
aerating or verticuting the individual
lanes should always overlap by a few
centimetres. Dwelling too long at the
same place while the implement is
running can damage the grass sward.
• To ensure that the extension cable
is not an impediment, turn the imple-
ment in such a manner that the cable
strain release on the bar always faces
the side that has been treated.
After work and to transport the im-
plement disconnect the power plug
and wait until the cylinder is stand-
ing still.
• Adjust the transport position 0 setting
(see “Setting the Working Position”)
when transporting the implement.
• Lift the implement to transport it over
steps and sensitive surfaces (e.g.
tiles).
• Always clean the implement after
each use (see “Cleaning, Mainte-
nance, Storage”).
• After having treated lawns with dense
moss growth, it is advisable to reseed
the lawn so that it can regenerate it-
self quicker.
Exchanging the cylinder
Switch off the implement, discon-
nect the mains plug and wait until
the cylinder is standing still.
Wear gloves when handling the cyl-
inder.
E 1. Turn the implement over.
2. Take the spanner (17) out of the
holder (see A No. 18).
3. Release the fastening screw (25)
and fold the bearing cover (26)
away.
F 4. Tilt the cylinder upwards and pull
the shaft (27) out of its seat.
5. Insert the new cylinder by revers-
ing the sequence.
Cleaning, maintenance,
storage
Work that has not been described
in these Instructions must be
carried out by a servicing agency
authorised by us. Only use origi-
nal parts.
Wear gloves when handling the cyl-
inder.
Prior to all maintenance and clean-
ing work always switch off the im-
plement, disconnect the plug from
the power socket and wait until the
cylinder is standing still.
General cleaning and mainte-
nance work
Do not jet water onto the imple-
ment and do not clean it under
flowing water. This would result
in the danger of an electric shock
and the implement could be dam-
aged.
• When work has finished remove plant
residues adhering to the wheels, in-
side the ventilation opening, the grass
ejector opening and the cylinder. Do
not use hard or pointed objects for this
purpose as they could damage the
implement.