Florabest FRT 450 A1 - Manual (Page 45)

45
GB MT
General description
The illustrations are on the
front fold-out page.
Survey
1 Upper handle
2 ON / OFF switch
3 Power cable
4 Strain relief
5 Screw sleeve to adjust the
length
6 Telescopic tube
7 Motor head
8a+8b Two-part protection cover
9 Cutting head with line spool
10 Spacing bow (flower protection)
11 Knurled nut and screw
12 Additional handle
13 Line cutter
14 Locking button
15 String spool
Functional description
The portable, hand-guided lawn trimmer is
powered by an electric motor. The trimmer
features a dual line spool as the cutting
device.
For grass trimming there are two nylon
lines rotating parallel with ground level.
An additional chassis facilitates edge trim-
ming. A hood covering the cutting device
protects the user.
The following describes the functions of
the operating parts.
Extent of the delivery
Carefully unpack the trimmer and check
that it is complete:
• Lawn trimmer
• Two-part protection cover
• 3 cross recessed screws
• Spacing bow (flower protection)
• Additional handle with screw
• 1 replacement string spool
Assembling instructions
Always disconnect the plug be-
fore working on the trimmer and
wait until the cutting lines have
completely stopped. There is the
danger of electric shock and the
possibility of injury by the cutting
lines.
Only use original parts and
always observe the line cutter
during assembly work as the
line cutter ( 13) can cause se-
ries injury!
You can assemble the protection
cover with or without a spacer.
Adding the spacer (optional):
1. Insert the spacer (10) into the
guide provided on the motor
head (7).
Assembling the protection
cover:
2. Join both parts (8a+8b) of the
protection cover together. Fold
the grey part of the protection
cover (8b) downwards (see
small Fig).
3. Apply the protection cover (8) to
the motor head (7) (see applica-
tion position ).
Ensure that the cutting strings
are not clamped in.
4. Secure the protection cover (8)