Florabest FRT 18 A1 - Manual (Page 11)

11
GB
it back into the appliance. It will
audibly snap in.
Do not insert the battery until
the appliance is fully assembled.
Risk of injury!
Recharging the battery
Overheating protection allows the
battery to be charged only from a
certain battery temperature. If the
battery is too warm after the equip-
ment has been used, it cannot be
charged immediately (charge indi-
cator red).
After a cooling period of a few min-
utes, the charging process starts
automatically (charge indicator
green).
1. Remove the battery (16) from
the appliance, as necessary.
2. Inser the battery (16) in the
charging compartment of the
battery charger (20). It will audi-
bly snap in.
3. Plug the battery charger (20) into
a mains outlet.
The charging indicator lamp (19)
lights up:
Flashing red: fault
(see “Troubleshooting”).
Permanent red light: charg-
ing current applied.
Flashing green: charging.
Permanent green light:
charging complete.
Recommended charging time is
approx. 1 hour.
4. When the battery is fully re-
charged unplug the battery
charger (20) from the mains.
5. Press the release button ( 17)
on the battery (16) and pull the
battery out of the battery charger
(20).
Used batteries
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see “Cleaning and Main-
tenance”).
Assembling instructions
Do not insert the battery until
the appliance is fully assembled.
Risk of injury!
To put on the protective cover:
1. Place the protective cover (14)
on the motor head (10) and
screw it down with the 3 Phillips
screws.
To put on the auxiliary handle:
2. Pull the ends of the auxiliary
handle (5) to extend the han-
dle and slide it over the handle
holder (22).
3. Screw down the screw (23) in
the auxiliary handle (5).
To install the cutting insert:
4. Place the cutting insert (13) on
the pin (24) on the cutting disk
(12) and pull out the insert until it
snaps in.