Florabest Z30597 - Manual (Page 8)

10 GB
®
Bringing into use Safety advice / Before use / Bringing into use
Do not use the product for
drinks!
Fill the device only with liquids at
temperatures of 0 - 40 °C.
Q
Before use
m CaUTIOn! Check that the device is
functioning properly! Check the pressure
sprayer before each use to ensure that it
is free of visible damage and is func-
tioning safely. To do this, carry out the
following tests and inspections:
Check the pressure sprayer for
visible signs of damage
j Check the container 5 for visible signs
of damage.
j Check the suction hose 18 for visible
signs of damage.
j Check the carrying strap 6 for visible
signs of damage.
Check connections
j Check that the hose connections are fitted
tightly.
j Check that the pipe connections are fitted
tightly.
Check that the pressure sprayer is
tight and leak-free
j Pump the empty pressure sprayer to
approx. 2 bar.
The pressure must not fall more than ap-
prox. 0.5 bar in a space of 30 minutes.
Check operation of the safety
valve
j Pump the pressure sprayer to approx.
2 bar.
j Pull the safety valve 3 up to the stop.
You must be able to hear the pressure
escaping.
Q
Bringing into use
Q
attaching the spray tube
without the extension
tube (Fig. B)
j Turn the union nut 16 anticlockwise to
release it from the handle 17 . Push the
spray tube 12 into the handle 17 as
far as it will go.
j Tighten the union nut 16 by turning it
clockwise.
note: You can also extend the spray
tube
12 by turning the lock nut 10 anti-
clockwise to release it and then pulling
out the extension. Then retighten the
lock nut
10 (see Fig. B).
Q attaching the spray tube
with the extension tube
(Fig. C)
j Loosen the union nut 15 slightly by turn-
ing it anticlockwise. Insert the spray
tube
12 into the union nut 15 .
j Tighten the union nut 15 by turning it
clockwise.
j Insert the extension tube 9 into the
union nut 16 .
j Tighten the union nut 16 by turning it
clockwise.
56222_flo_Drucksprüher_Content_LB4.indd 10 02.12.10 16:20