Florabest FGS 10 A1 - Manual (Page 13)

13
GB IE
axle click into place in the cor-
responding notches on the left
and right-hand side of the tool.
• To remove the
wheels (5), push
the wheels apart
using your index
finger and thumb (clothes peg
grip) and remove the wheels.
• Swinging the Equipment: Push the
catch ( 6) on the right-hand side of
the blades. You can now tilt the blade
up and down.
• Push the tool over the ground using
the wheels ( 5). This will ensure
that you keep an even cutting height.
The telescopic shaft ( 20) will
make work easier.
• Grass is best cut when dry and not
too long.
Use as a hedge trimmer
• Move the unit forward evenly.
• The double-sided cutting heads en-
able cutting in both directions or by
swinging the unit from side to side.
Changing the blades
Remove the battery (7) from the unit
before changing the blades (11/12).
1. Press the two quick-release
catches (25) on the battery (7)
and pull the battery out of the unit.
2. Push the safety switch (26) on
the underside of the unit to „UN-
LOCK“ and lift the blade cover
(27) off.
3. Remove the whole blade unit
(11/12).
4. Position the blade onto the unit.
Make sure the fixed blade plate
(28) points outwards. The re-
cesses on the blade fit onto the
pins in the equipment casing.
Note: If the blade drive (29) has
turned around, turn it by hand until
you can position the blades (11/12).
5. Place the blade cover (27) onto
the unit and move the safety
catch (26) to „LOCK“.
6. Place the battery (7) into the unit
again.
Maintenance and Cleaning
Leave any work not covered in
this manual to our Service Cen-
tre. Only use original parts.
Remove the battery ( 7) from
the unit before servicing it.
Wear gloves when handling the
blades ( 11/12).
Clean and service the unit regularly as fol-
lows. This guarantees a long life for your
unit:
• Check the covers and guards for dam-
age and correct position. If necessary,
replace.
• Always keep the unit clean. Never use
cleaning agents or solvents, which
can cause irreparable damage to the
unit. Chemicals can attack the plastic
components on the unit.
• Clean the blades carefully after each
use. Wipe it off with an oily rag or
spray metal-protection spray on them.