Disassembly, Maintenance, Care – Crivit PZ-2116 User Manual
Page 6: Storage, 3 years warranty
8
GB/IE
Caution: The frame is under tension
when folded and will always return
to the tent form. Make sure that this
tensioning force does not cause you any
injuries.
1. Remove the article from the bag.
Caution: Hold the article tightly when
removing the rubber band.
2. Remove the rubber band and throw the
article into the air.
3. Fix the four guy-ropes and the four eyelets
below the article using the tent pegs and
close the hook-and-loop fasteners around the
crossing tent poles (figure B).
Disassembly
NOTE!
Disassemble the tent, if possible, when clean
and dry to prevent the formation of mould and
mildew. After disassembling in rain, immedia-
tely dry the tent. Clean all the parts thoroughly
before packing them away.
1. Remove the tent pegs and the guy-ropes.
2. Grip the back tent pole at the bottom
(figure C).
3. Now take the upper tent poles one at a time
and finally the bottom tent pole with the
opening (figure D).
4. Hold the middle of the tent poles tightly in
one hand.
Important: Hold the tent poles tightly
and do not let them go. The tent poles
are under tension and could injure you.
5. Stand the article upright in front of you and
keep holding the tent poles in the middle
(figure E).
6. Use your free hand to grip the upper tent
poles in the middle and press them from
above all the way down onto the tent poles
at the bottom (figure F).
7. Pull the tent poles inwards towards yourself
(figure G).
8. Put the tent poles that you are still holding
over one another. Make sure that the tent
poles with the rubber band are on top
(figure H).
9. Place them all tidily above one another and
pull the rubber band around the article.
Put the article, the tent peg sack with the tent
pegs, and the guy-ropes in the bag, and
close the bag (figure I).
Maintenance
In the case of small tears and holes, use a repair
kit from a specialist shop. Immediately replace
broken tent poles. Oil the zips a little if they
become stiff.
Care
Brush dirt off the dry tent surface; if necessary
treat with clean water. Do not use a chemical
cleaning product. Seal the tent seams from time
to time. For this, use a commercial seam sealer.
Storage
Store the product in a dry place to prevent the
mould and weather marks. If it is not used for
a longer period, take the product out of the
packsack and store it in a dry place out from
direct sunlight.
Notes for disposal
Please dispose of the packaging and product
separated according to materials and in an
environmentally-friendly manner! Dispose of the
product through an approved waste disposal
firm or by using your local municipal administrati-
on. Observe the current applicable legislation.
3 years warranty
The product was produced with great care and
under constant supervision. You receive a three-
year warranty for this product from the date of
purchase. Please retain your receipt.
The warranty applies only to material and
workmanship and does not apply to misuse or
improper handling. Your statutory rights, espe-
cially the warranty rights, are not affected by this
warranty.