Preset store – Electro-Voice Speaker System User Manual

Page 22

Make sure that the new preset is appropriate for your system, and that

connections to your system are correct for the current configuration.

Failure to do so could cause unexpected results or damage to the

system or its components.

To exit the Recall process without loading a new preset, press the Edit, Setup or

any of the DSP block buttons. (Edit or Setup buttons will return the display to

run-time mode. DSP block buttons will display the corresponding DSP block edit

screen.)

Preset Store

Edited presets can be stored in one

of 20 User Preset locations. (U01 –

U20) To store a preset, press the

Store button. The LCD display will

switch to the Store Program screen. Use the

Value Up and Down buttons to select the user

preset location you wish to designate as the

destination. Locations that already have presets saved in them will display a

preset name. Empty locations will display “?” in the name field. You may select an

empty location, or a location of a preset that will be over-written.

Press the < Select > buttons to

navigate down to the preset

name field. Use the Value Up

and Down buttons to select the

field for each letter / symbol

character. The DC-One provides the complete

ANSI character set, including lower-case &

upper-case letters, numerals and symbols. Pressing and holding the Value Up and

Down buttons will scroll rapidly through the character set. Press the < Select >

buttons to move to the next or previous character position.

When the preset is

named, press

Store again. If the

preset location was

previously empty,

the display will

prompt “Are you

sure? Press Store”. If you are overwriting an existing preset the display will

prompt “Overwrite Preset? Press Store”. In either case, press Store again to

proceed and store the new preset.

To Exit Store without saving the edited preset,

press the Edit, Setup or any of the DSP block

buttons. (Edit or Setup buttons will return the

display to run-time mode. DSP block buttons

will display the corresponding DSP block edit

screen.)

SELECT

Recall

Edit

Setup

COMPARE

SELECT

VALUE

Store