Crivit SP - 603 MH - Manual (Page 5)

5
GB / CY
3. Changing the visor
Removing the visor
• Loosen the visor's screw using a screwdri-
ver (Fig A).
• Carefully lift up the visor (Fig B).
Repeat the process on the other side of the
helmet.
Replacing the visor
• Reinsert the visor.
• Screw on the visor using a screwdriver.
Repeat the process for the other side of
the helmet (Fig A).
Repeat the process for the other side of the
helmet.
CAUTION: REMEMBER TO
CHECK THE VISOR IS FIRMLY
IN PLACE AND FULLY FUNC-
TIONAL!
4. Retention system/ Safety faste-
ning
Your motorcycle helmet is fitted with a high-
quality retention system for optimal adjust-
ment.
Proceed as follows to ensure the chinstrap is
optimally adjusted:
• Put on your helmet and push the clip into
the casing.
• The chinstrap must lie snugly against the
neck and cheek.
• The helmet should not become dislodged
if you pull it forwards/lift it up from the
back of the neck. If the helmet loosens
even though you have pushed the clip all
the way in, you need to tighten the entire
chinstrap.
• If the chinstrap is too tight, you must
lengthen it. At least 5 notches on the
ratchet should be engaged.
• To open the lock, pull out the red nylon
strap from the casing whilst pulling out
the clip.
5. Inside padding
• To remove the motorcycle helmet cheek
pads, please release the buttons as shown
in Diagram C. Then pull out the plastic
clip between the helmet shell and the
helmet interior, see Diagram D.
• To reattach the cheeks pads to the helmet,
replace the plastic clip between the
helmet shell and the helmet interior before
fastening the pad using the buttons.
• The acoustics padding can be removed or
replaced using the Velcro fastening.
Replacement parts and replacement visors
can be obtained from:
SPEQ GmbH
Tannbachstr. 10
•
D-73635 Steinenberg
Hotline: + 800 30 777 999
E-Mail: [email protected]
•
Web: www.speq.de