Crivit Z31983 - Manual (Page 4)

4 GB/IE
§
Tent assembly
Please ensure that the product is only
assembled by people with the appropriate
skills.
Note: The polyester material of the tent
consists of water-repellent material.
It is possible that during the first rainfall
the tent will not be completely watertight.
However, the threads of the tent will contract
when exposed to water so that after a short
time the tent will become watertight.
Erect the product in accordance with the
illustrations A to E.
Illustration A:
1. Place the outer tent 1 flat on the ground.
The holders for the poles 3 4 5 must be
facing upwards.
2. Push the poles marked in different colours
carefully through the holders marked with the
same colour.
Illustration B:
3. For pole 5 , insert the two ends of pole into
the eyelets on the pole 5 sleeves for front
door.
4. Set the tent 1 up and fix the poles to the
ground sleeve of the floor fastening.
Illustration C:
5. Fix one side of the tent in the ground with
the tent pegs
7
. Then take hold of the other
end of the tent and pull it apart in such a
way that the tent is taut.
6. Secure the other side of outer tent 1 by
tensioning the floor fastenings with the tent
pegs 7 .
7. Secure the poles 3 4 to the outer tent 1
by the pole clips 10 .
Illustration D:
8. Now secure the outer tent 1 with the guy
ropes 6 and the tent pegs 7 .
9. Open the sunroof (entrance), roll it and
attach it with the two fasteners.
10. Stretch the tent until taut, pull all of the corners
and guy ropes 6 until they are tight. Do not
over-tighten the guy ropes 6 , if the strength
of the wind increases the attachment point
and seam of the tent might tear.
11. Lay out the detachable groundsheet 8
under the living room, peg down
7
the
groundsheet at the eyelets of corners.
Illustration E:
12. Hang the inner tent 2 into the plastic “O”
rings of the outer tent 1 that are designated
for that purpose, the sequence is from back
to the front.
13. Peg down the 4 corners of groundsheet
of inner tent at the plastic “O” rings. The
sequence is from back to the front as well.
14. In case you need simply hang the separate
partition wall 11 into the plastic “O” rings of
the inner tent 2 that are designated for that
purpose.
Illustration F:
15. In order to use the entrance as a sunshade,
put the entrance support poles
12
into
each other and fasten the pointy end
of the entrance support poles
12
to the
corresponding holes of the sunshade.
16. Secure the entrance support poles
12
with
the guy ropes
6
and the tent pegs
7
.
17. If it rains, close the sunshade to avoid water
puddles on top of the sunshade.
96531_14_Crivit_IE_PL_CZ_01.indb 4 6/1/14 11:07 am